4 out of 5 found this review helpful.
Weather proofing a switch
I used this to make a new rubber switch cover on my flashlight. I rounded the end of a new round pencil, placed a tight fitting rubber washer on it approximately 1/8 inch down, then applied hot glue to the back of the washer to create the flange. When the glue was cool I removed the washer and dipped the exposed end of the pencil into the mold builder, tapped it lightly to get the air bubbles out and stood it in a vertical position to dry. After six hours I applied the second and final coat. When finished the new gray cover peeled off the pecil easily by loosening the flange and rolling it. It came off inside out but it inverted without harm.
Was this review helpful? Yes No
Report inappropriate review